Three Different Ways to Cut a Cement Board - written by Robert Melkonyan

There are numerous solutions to cut a cement panel just like there are various other techniques for you to do anything you set your mind to but not every single way can be one of the best way, that is why we're going to show you three distinct means for you to cut a cement table and still get incredible results, let's take a look at these excellent techniques:

Using a circular saw

This is by far one of the simplest ways to cut cement board, circular saws typically have a redundant abrasive blade which cuts through the board as if it were slicing through butter nevertheless the easiest way is not often one of the best way, using a circular saw can produce a lot of dust and debris and depending on the kind of blade that your saw uses the act of actually slicing through a cement table could be way too tough on it so in case you aren't certain about the type of circular saw you've then it may be a better idea for you to approach this task in a different way. Some folks don't care about their saws and if they break they often have a few additional hundreds to buy a new one, if this sounds like you then by all means go ahead and experiment a bit.

Applying cement Shear gear

Utilizing cement Shear could be one of the greatest solutions to cut to a cement board, this tool looks very much like a power drill actually; the whole mechanics is 80% similar to that of a power drill with the distinction that instead of a drill it has a scissor-like attachment at the very tip. Utilizing cement Shear gear makes a good deal of noise just like making use of a circular saw so unless you are doing this throughout the day then you may well want to take a look at the next choice for you to cut by way of a cement board. Furthermore this kind of instrument can also make a great deal of debris but within the plus side you could have considerably of control over the direction and also the way that you will be cutting through the panel and as we all know what you're doing to stop the job precision does truly matter.

Applying a single carbide tip tool

This can be a rather rudimentary approach applied by numerous folks who preferred to go old school when cutting this kind of boards. This tool looks considerably like a razor knife to the main distinction is around the cutting blade that is carbide tipped. First you want to mark the section that you are planning to cut via with a pencil or a marker, make positive that you are able to see the line incredibly well. Then applying the carbide tip tool commence running the blade down the line you just made to be able to scrape or cut a clear path, you may possibly have to do this many times until you happen to be able to get by the board. Once all the slicing is complete then apply pressure on the back in the table behind the reduce line, snap the table and get your cutting instrument and start scraping along the line to separate the table in two pieces. This method doesn't make very much debris and even should you do it at midnight it won't be as loud as applying the tools mentioned above.